Grizzly T10125 Kitchen Utensil User Manual


 


       
        
Figure 10.
Figure 10.

HigV^\]iZY\Z
Dji[ZZYIVWaZ
       

       
       
  
     
       

19.       

20.       


      

21. 
        


        

Installing or adjusting a carbide cutter:
1. 
2.        

3. 
4.         
    
       

Note:Proper cleaning is critical to achieving
a smooth finish. Dirt or dust trapped between
the insert and cutterhead will slightly raise the
insert, and make noticeable marks on your
workpieces the next time you cut.
5.       
        
  

Note:Excess oil may squeeze between the
insert and cutterhead or in the screw hole,
thereby lifting the insert or screw slightly and
affecting workpiece finishes.
Figure 11.


Insert Service



       

Figure 11