Filter
Top Products
1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the freezer accessories inside and
outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the freezer.
•Your freezer is designed for freestanding installation only.
It should not be recessed or built-in.
• Place the freezer on a floor strong enough to support it fully loaded.
• When moving the freezer, never tilt it more than a 45-degree angle.
This could damage the compressor and the sealed system.
•Ifthe freezer is tilted let it stand in an upright position for at least 24
hours prior to plugging. This is to allow the refrigerant to settle.
•Toassure your freezer works at the maximum efficiency it
was designed for, you should install it in a location where there
is proper air circulation, plumbing and electrical connections.
• The following are recommended clearances around the deep freezer:
Sides 100mm
Top 100mm
Back 100mm
Installing Your Freezer
Unpacking Your Freezer
Adjusting Your Freezer
Proper Air Circulation
5
•Your freezer have removable baskets.Itallows you
to store food more accessably or you can remove it if not needed.
Food Storage Basket
Castors
Your freezer can be equipped with castors for easy moving.
We recommend installing castors before using the freezer.
Install following these easy steps:
1.Remove the food basket from the freezer
2.Slowly tilt the freezer on its side.
3.Tap one castor into the bottom of the freezer.
Fasten the castor into place with screws provided.
4.Install the other three castors in the same manner.
5.Return the freezer to its upright position and replace the food basket.
Note: it is important to wait for 24 hours after installation before plugging
in the unit to alow the refrigerant to stabilize
8