Filter
Top Products
Turning on the Appliance
.5.
Starting a wash cycle...
Make sure that the plug for the appliance is inserted into the
wall socket.
Make sure that the water supply is turned on to full pressure.
Load the dishes.
Pour in the detergent.
Press the "POWER" button, and the “END” light will turn on.
Turn the knob located on the right of the control panel until the
number or symbol for the cycle setting is aligned with the
refrence mark (see the section entitled, program overview).If
the knob rightly aligned with the refrence mark you want to
choose, you must turn the knob to with the mark of “RESET” .
Then back to first step.
After five seconds the “END” light will turn off, the wash cycle
will begin.
-
-
-
-
-
-
-
A cycle that is underway can only be modified if it has been run-
ning for a short time. Otherwise, the detergent may have already
been used, and the appliance may have already drained the wash
water. If this is the case, the detergent dispenser must be refilled
(see the paragraph entitled, "Loading the Detergent").Rotate the
knob to the mark of “RESET” then select right programme.
When the buzzer constantly beeps six times, the “END” light will
turn on and the cycle has finished. Turn off the appliance using
the "POWER" button, turn off the water supply and open the
door of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better.
Cancelling or modifying a wash cycle setting...
At the end of the wash cycle...