Filter
Top Products
English
Troubleshooting Guide
Problem Possible Causes Solution
The compressor
makes a buzzing
noise when the
machine is on.
The voltage is lower than
required. This unit requires a
minimum of 120 volts.
Turn off the icemaker. Make sure the voltage is
120v and restart.
The LCD display
shows “POUR”.
There is no water in the water
storage tank or the water
level is too low.
The filter is blocked.
Fill the water storage tank with water and
restart the unit.
Clean the filter with a soft, flexible toothbrush.
The LCD display
shows “FULL”
There is too much ice in the
ice storage basket.
The temperature is too low.
Remove some ice from the ice storage basket.
Place the icemaker in a warmer place.
There is no display
on the LCD screen.
The fuse is blown. Replace the fuse.
The ice cubes are
fusing together.
The ice-making time is too
long.
The water temperature in the
inner liner is too low.
Stop the machine and reset the ice-making
time. Start the machine after the ice block
melts.
Replace the water in the inner liner. The sug-
gested water temperature is 44.6˚ to 77˚F.
Water is not freezing
during the normal
ice-making cycle.
The refrigerant is leaking.
There is a block in the refrig-
erating system.
Contact an authorized service center.
9