Filter
Top Products
Troubleshooting
Refrigerator control is set
too cold.
Set refrigerator control to a warmer setting. Allow
24 hours for temperatures to stabilize.
Food stored in
drawers freezes.
PROBLEM CAUSE SOLUTION
tempeRatuRes aRe too Cold
Meat Keeper Temperature
Control is set too cold.
Adjust Meat Keeper Temperature Control to a lower
setting. (Meat should be stored at a temperature just
below the freezing point for maximum fresh storage
time. It is normal for ice crystals to form due to the
moisture content of meat.)
Food stored in Meat
Keeper freezes
(some models).
Electronic control system
has detected a performance
problem.
Call your HAIER service representative, who can
interpret any messages or number codes ashing
on the digital displays.
Digital temperature
displays are
ashing.
Doors are opened too
frequently or too long.
Door is slightly open.
Condenser is dirty.
Warm air enters the refrigerator whenever the door
is opened. Open the door less often.
See PROBLEM section OPENING/CLOSING OF
DOORS/DRAWERS.
Clean condenser.
Freezer/Refrigerator
temperature is too
warm.
tempeRatuRes aRe too WaRm
Freezer control is set too warm. Set freezer control to a colder setting. Allow 24
hours for temperature to stabilize.
Freezer temperature
is too warm.
Refrigerator
temperature is
satisfactory.
Refrigerator control is set
too warm.
Set refrigerator control to a colder setting. Allow
24 hours for temperature to stabilize.
Refrigerator
Temperature is
too warm. Freezer
temperature is
satisfactory.
Meat Keeper Temperature
Control is set too warm.
Adjust Meat Keeper Temperature control to a
colder setting.
Temperature in
the Meat Keeper
is too warm (some
models).
Weather is hot and humid.
Door is slightly open.
Door is opened too often or
too long.
Open containers.
Raise the refrigerator temperature slightly.
Close the door gently.
Open the door less often.
Keep containers covered.
Moisture collects
on inside of
refrigerator walls.
WateR/moistuRe/fRost inside RefRigeRatoR
Vegetables contain and give
off moisture.
It is not unusual to have moisture on the bottom
side of the cover.
Move humidity control (some models) to
lower setting.
Water collects on
the bottom side of
drawer cover.
27