Filter
Top Products
12
16) Flush with an additional 1 gallon (4 quarts or 4 liters) of fresh tap water and allow to drain
into the bucket.
17) Reinstall the silicon stopper and drain cap (see Draining Instructions).
18) Install a fresh water bottle (see Preparing and Loading Your Dispenser for Use).
19) Dispense 1 quart (1 liter) of water from each faucet and taste to make sure the bleach
solution is completely removed.
20) If you continue to taste the chlorine from the bleach solution, repeat steps 11 – 20 until the
taste is gone.
21) Plug in the dispenser. Then turn on the hot and cold power switches (on the back of the
dispenser).
To Remove Mineral Deposits:
Mix 2 quarts (2 liters) of water with two quarts of vinegar OR mix 1 gallon of water (4 liters)
with 16 ounces (454 g) of citric acid crystals. Bleach does not remove mineral deposits. Do this
in place of step 6 above when removing mineral deposits.
Preparing for Vacation:
For long vacations or absences, set both power switches (on back of the dispenser) to the OFF
position.
Unplug the water dispenser.
Remove the water bottle.
Drain the water tanks (see Draining Instructions)
Dry the separator thoroughly on both the top and bottom (see Cleaning the Separator).
After returning from vacation, make sure to sanitize the water tanks before using the dispenser (see
Sanitizing and Cleaning the Water Tank).