Filter
Top Products
5
3. To remove: Turn mixer off and
unplug. Eject beaters or other
attachments.
4. Grasp mixing shield in one hand,
while holding
mixer in other
hand. Pull
shield straight
out, then up,
to remove.
Flat Beaters, Straight Wire
Beaters and Whisk
1. Make sure mixer is unplugged and
speed control is set to OFF.
2. Insert a beater or attachment into an
opening on the
bottom of the
mixer. Push
until it clicks
into place.
Repeat with
other beater or
attachment.
Twisted Wire Beaters and Dough
Hooks
1. Insert the wire beater or the dough
hook with the
collar into the
opening indi-
cated by the
illustration on
the mixer.
2. Align tabs on the beater or dough
hook with the
slots in the
opening. Push
until it clicks
into place.
Repeat with
other beater or
dough hook.
To Insert Attachments
5. Wash mixing shield in hot, soapy
water. Rinse and dry.
Mixer Storage Case
Wipe clean with a damp, soapy cloth.
Collar
Tab
Slot
840126200 ENv00 3/19/04 1:45 PM Page 5