Filter
Top Products
Page 4SKU 4832 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Capacity
Wire - .031” to .197”
Sheet - 35 Gauge to .079”
Gears 3:1 Gear Ratio
Includes
2 Smooth Rollers
1 Wire Roller
2 Pattern Rollers
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If
any parts are missing or broken, please call Harbor Freight Tools at the number shown
on the cover of this manual as soon as possible.
SET UP INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram near the end of this manual.
Assembly
Remove the protective plastic coverings from all items including the attached 1.
Rollers.
Connect the Operating Handle (1) to the Shaft Gear (10) with Bolt (11) and 2.
Washer (12), as shown on the cover.
Slide the Working Handle (2) between the Right and Left Screw Gears (4,5) into 3.
the hole on top of the unit.
Mounting
The Mill must be mounted before use. Choose a work surface that is at, level, 1.
and capable of bearing the weight of the Mill and workpieces.
Operating Handle must be positioned to rotate freely.2.
Using the Base of the Mill as a template, mark with a pencil where the holes need 3.
to be drilled. Verify that installation surface has no hidden utility lines before
drilling.
Drill holes in the work surface and mount the Mill rmly using appropriate 4.
hardware (not included).