Filter
Top Products
SKU 66473 For technical questions, please call 1-800-444-3353. Page 3
Push Block Latches
4. To remove the Cutting Frame (10 or 12),
remove the four wing nuts holding it in place.
WARNING: Handle the Cutting Frame by the
outer edge only. The blades are sharp and
can cause injury if handled. The blades are
not removable from the Cutting Frame.
To replace the Push Block, place it against 5.
Block Plate A (4) with hooks protruding
through holes in Block Plate A. Then x it in
place with the two swivel latches.
To replace the Cutting Frame, position it on 6.
the end of the End Support (2) and attach it
with the Wing Nuts.
Wing Nuts(15)
NOTE: Always use the Push Blocks and Cutting
Frames in matched pairs. Using mismatched
Block and Cutting Frame will damage the
tool.
OPERATION
Pull the Lever (1) back, which will pull the 1.
Push Block back from the Cutting Frame.
Place a bowl beneath the End Support (2) 2.
to catch the cut french fries as they are
produced.
Place the potato or vegetable to be cut in the 3.
Food Tray (6). Align the vegetable roughly
with the center of the Cutting Frame.
Press the Lever (1) forward. The Push Block 4.
will press the vegetable through the Cutting
Frame. Stop pressing the Lever forward once
the vegetable has been cut.
CLEANING
Remove both the Cutting Frame (10 or 12) 1.
and Push Block (11 or 13).
Lift Food Tray (6) out of tool. 2.
Wash Cutting Frame, Push Block and Food 3.
Tray in dishwasher, or by hand using hot
water and detergent.
Wipe off the rest of the tool using a clean 4.
damp cloth with light detergent. Wipe it dry
after cleaning.
Wing Nut (19)