Filter
Top Products
Model EEE-141,142, 143, 144
3-13. DISCARDING OIL
FROM VAT USING
OPTIONAL OIL
DISCARD SHUTTLE
Figure 1
Figure 2
WITH PROLONGED USE, THE FLASHPOINT OF
OIL IS REDUCED. DISCARD OIL IF IT SHOWS
SIGNS OF EXCESSIVE SMOKING OR FOAMING.
SERIOUS BURNS, PERSONAL INJURY, FIRE, AND/
OR PROPERTY DAMAGE COULD RESULT.
1. Open the door, lift-up on the drain pan stop and pull-out the
drain pan assembly, using the handle on the drain pan.
Figures 1 & 2.
2. Press and hold (either one) until display shows
“*FILTER MENU*”, along with “1.EXPRESS FILTER?”.
3. Press and release button twice until display shows
“3.DISPOSE”. Press
√√
√√
√ button and display shows
“DISPOSE?” “YES NO”.
4. Press
√√
√√
√ button and “IS DISPOSAL UNIT IN PLACE?
“YES NO”shows in display.
If Bulk Oil Dispose is set to “YES”, “DRAIN VAT?” YES NO”
shows in display
5. With discard shuttle rolled into place (Figure 3), press
√√
√√
√ button
and display shows “OPEN DRAIN”. Pull-out on drain knob
to open drain and display shows “DRAINING”. Oil now
drains from the vat into the shuttle.
6. Display shows “VAT EMTY “YES NO”. Verify that vat is
empty, and press
√√
√√
√ button.
7. Display shows “CLN VAT COMPLETE” “YES NO”. Once
vat is clean, press
√√
√√
√ button. and display shows “CLOSE
DRAIN”. Push-in on the drain knob.
If Bulk Oil Dispose is set to “YES”, “
√√
√√
√=PUMP” “X=DONE
shows in the display. Press X button.
8. Display shows “MANUAL FILL POT”, followed by “IS POT
FILLED?”, along with “YES NO”. Fill the vat to the lower
indicator line on the rear of the vat and then press
√√
√√
√ button.
See Filling or Adding Oil instructions from Section 3-3.
Fryer returns to normal operation.
9. Remove the discard shuttle from under fryer and replace with
the filter pan assembly.
909 3-16
Figure 3