Filter
Top Products
Model OFE/OFG/OEA/OGA-341, 342
1-4. ERROR CODES In the event of a control system failure, the digital display shows
An error message. These messages are coded: “E4”, “E5”, “E6”,
“E10”, “E15”, “E20”, “E31”, “E41”, “E46”, and “E92”. A
Constant tone is heard when an error code is displayed, and to
silence this tone, press any button.
DISPLAY CAUSE PANEL BOARD CORRECTION
“E4” Control board Turn switch to OFF position, then turn switch back to ON;
overheating if display shows “E4”, the control board is getting too hot;
check the louvers on each side of the unit for obstructions
“E5” Shortening Turn switch to OFF position, then turn switch back to ON;
overheating if display shows “E5”, the heating circuits and temperature
probe should be checked
“E6-A” Temperature Turn switch to OFF position, then turn switch back to ON;
probe open if display shows “E6” the temperature probe should be
checked
“E6-B” Temperature Turn switch to OFF position, then turn switch back to ON;
probe shorted if display shows “E6” the temperature probe should be
checked to replace, per Temperature Probe Replacement
Section
“E10” High limit Reset the high limit by manually pushing up on the red
reset button; if high limit does not reset, high limit must be
replaced per High Limit Temperature Control Section
“E15” Drain switch Close drain, using the drain valve handle; if display still
failure shows “E-15”, check the drain microswitch per Drain
Microswitch Section
“E31” Elements not Check to make sure the elements are hinged all way down
hinged all the into the frypot; check for obstructions under elements
way down
“E41”, Programming Turn switch to OFF, then back to ON; if display shows any
“E46” failure of the error codes, try to reinitialize the control (Special
Program Mode Section of Operator’s Manual); if error
code persists, replace the control panel per Complete
Control Panel Replacement Section
1003 1-5