Filter
Top Products
TROUBLESHOOTING
1812 SLICER
SYMPTOM
POSSIBLE CAUSE
Motor will not start, switch in start
position.
1. No power to slicer.
2. Carriage tray unit not in home position.
3. Check power cord.
Power switch in run position, motor will
not stay running.
1. Off – On – Start switch malfunction.
Slicer will not shut off.
2. Off – On – Start switch malfunction.
Hard to slice.
1. Blade dull.
2. Carriage bearing assembly not free on slide rods.
NOTE:
If symptom(s) persists after possible causes have been checked, contact your local Hobart Service Office.
1812 SLicer Technical Maunal Page 17 of 49