Filter
Top Products
– 11 –
Change a Program
1. Press the PROGRAM # UP
arrow key until the desired program number is displayed.
2. The current settings are displayed.
3. Change only the settings that need to be changed.
4. Use the appropriate UP and DOWN
arrow arrow keys to adjust the settings.
5. Press and hold ENTER key for 3 seconds until a beep is heard.
6. Change is complete.
7. If the PROGRAM # UP
arrow key does not change the program number, press OFF and
BAKE to reset and begin again.
Finding and Using a Program
1. Press the PROGRAM # UP arrow key until the desired program number is displayed.
2. Allow the OVEN TEMPERATURE to reach the SET TEMPERATURE.
3. Load the oven and close the oven door.
4. Press TIMER START. The flashing light in the BAKE TIME display indicates the timer is counting
down.
5. When the BAKE TIME display reaches 000, the display flashes and the beeper sounds.
6. Press TIMER STOP to silence the beeper and restore the initial program settings to the displays.
Heat and rack rotation remain on until you press TIMER STOP a second time.
Operational Hints
• If you press TIMER STOP during a baking cycle, the timer will stop and the rack rotation will stop
at the next load-unload position.
• When the baking cycle is completed (BAKE TIME reads 000), the display flashes and the beeper
sounds. Press TIMER STOP to silence the beeper and restore the initial bake settings to the
displays. Heat and rack rotation remain on until you press TIMER STOP a second time.
• The OVEN TEMPERATURE displays the actual oven temperature until it reaches and stays
within 10 degrees of the SET TEMPERATURE. The SET TEMPERATURE will be displayed as
both the OVEN TEMPERATURE and the SET TEMPERATURE.