Filter
Top Products
– 4 –
Installation, Operation and Care of
MODEL FD4-500
FOOD WASTE DISPOSER
SAVE THESE INSTRUCTIONS
SAFETY
RECOGNIZE SAFETY INFORMATION
When you see this symbol on your machine or in this manual, be alert to the potential
for personal injury.
READ ALL INSTRUCTIONS
Read this owner's manual before using the machine. Failure to follow the instructions provided could result
in personal injury or equipment damage.
KEEP OUT OF REACH OF CHILDREN
This disposer is intended for commercial use only.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN) WITH
REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND
KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING
USE OF THE APPLIANCE BY A PERSON RESPONSIBLE FOR THEIR SAFETY.
DO NOT PUT HANDS OR ANY IMPLEMENT IN THE DISPOSER WHILE IN OPERATION.
NEVER FEED WASTE BY HAND PAST VINYL SILVER TRAP SCRAPPING RING.
DO NOT OPERATE IF DAMAGED.
Do not install or operate this disposer if the disposer has been dropped or damaged in any manner. Contact
the nearest factory-authorized service center for examination, repair, or adjustment. (Refer to the service
list included in the Owner's Information Packet.)
DO NOT LEAVE DISPOSER UNATTENDED WHILE OPERATING.
SET THE POWER SWITCH TO OFF BEFORE CLEARING JAMS OR REMOVING OBJECTS FROM
DISPOSER.
When the disposer is wired to a Group 5 Control Panel, SHUT OFF the branch circuit main switch or
disconnect.
When the disposer is wired to a Group 6 Control Panel, TURN OFF emergency disconnect.
Use long-handled tongs or pliers to remove objects.
TO REDUCE THE RISK OF INJURY BY MATERIALS THAT MAY BE EXPELLED BY DISPOSER, DO
NOT PUT THE FOLLOWING INTO DISPOSER: drain cleaner; glass, china, or plastic; large, whole
bones; metal (bottle caps, tin cans, aluminum foil, etc); whole cornhusks.
ALWAYS KEEP VINYL SILVER TRAP SCRAPPING RING OR SINK STOPPER IN PLACE, EVEN
WHEN NOT IN USE.
This reduces the risk of objects falling into the disposer.
WHEN CLEANING KITCHEN AND DISPOSER AREA, ONLY DAMP WIPE OUTSIDE OF DISPOSER
AND CONTROLS. DO NOT AT ANY TIME HOSE DOWN THE EXTERIOR SURFACES OF THE
DISPOSER AND CONTROLS.