Filter
Top Products
– 8 –
MAINTENANCE
WARNING: TURN MACHINE OFF AND UNPLUG THE POWER SUPPLY CORD BEFORE DOING ANY
MAINTENANCE.
Inspect the machine weekly to ensure that it is in proper working order. Fit the cut knife or whip knife and then
check the following:
1. The machine stops within 4 seconds after the arm has been swung away from the center of the bowl cover.
2. The machine cannot be started with the bowl removed and the arm swung into position above the center of
the bowl cover.
3. Unplug the power supply cord and check to make sure that it is in good condition with no cracks or cuts.
4. The blades of the cut knife are in good condition and have a sharp cutting edge.
If a problem occurs, contact your local Hobart Service Office before operating the machine.
TROUBLESHOOTING
PROBLEM CAUSE REMEDY
Machine won't start. Fuse or circuit breaker Have electrician check circuit.
interrupting power.
Bowl not in place. Make sure bowl locating pins are in proper
position in the grooves on the bowl recess,
and the bowl is seated on the base and
locked in position.
Arm not in position over Lift arm and rotate to center of bowl cover.
center of bowl cover. Lower arm over center of bowl cover to
secure it in position.
Machine not plugged in. Plug machine into electrical outlet.
Machine stops while Motor overloaded. Allow motor to cool; motor will restart when
operating and won't it has cooled.
restart.
Fuse or circuit breaker Have electrician check circuit.
interrupting power.
FORM 18655 (8-93) PRINTED IN U.S.A.