– 27 –
Final Rinse
For FT1000 Base models, the required minimum hot water temperature for the
nalrinseis110°Fwhenanelectricorsteamboosterheaterissupplied(same
connectionpointforll).ForFT1000EnergyRecoverymodels,theminimumcold
watertemperatureforthenalrinseis55°Fwhenanelectricorsteambooster
heater is supplied. The energy recovery models have a single 1” NPT female cold
water connection point.
Remove the nal rinse arms and purge the nal rinse system
prior to operation. This will reduce the possibility of clogging the nal rinse
nozzles. To properly purge the unit, activate the nal rinse for 3 to 5 minutes
and then reinstall the rinse arms.
Drain
For machines without Auto Clean or Auto Delime, connect the drain at the 2” NPT
threadedttinglocatedateithertheloadendortheunloadendofthemachine.
NOTE:Theplugttingandthethreadeddrainttingcanbeinterchangedtoreverse
the drain end of the machine.
On machines equipped with Auto Clean and/or Auto Delime, the master drain
assembly is located at the unload end of the machine. Connect the drain at the 2”
NPTthreadedtting.SeeRELOCATINGMASTERDRAINTOLOADEND(page
14) if machine drain is to be located at load end.
NOTE: On machines equipped with Auto Clean and without the ASR section, the
master drain assembly is located at the unload end only.
Ifagreasetrapisrequiredbycode,thedrainshouldhaveaowrateof38gallons
per minute.
Line Strainer
Line strainers on the machine should be cleaned after installation and within the
rstweekofoperation.Thelinestrainerswillcollectoilsandothercontaminants.
Cloggedlinestrainerswillcauserestrictionstotheowofwaterorsteamandwill
reduce overall performance of the machine.
Steam Supply (When Equipped)
Check all steam lines for leaks, particularly unions. Tighten if necessary.
Thesteamsupplymustbe10-45psigowingpressureatthedishwasher.Machines
haveasingle1½”NPTfemalettingforconnectionunderneaththeunloadend.
NOTE: Ifavailable steam pressure isless than 10 psiowing at themachine,
operationalcharacteristicsmaybelimitedbecauseofinsufcientdeliveryofsteam.
If this occurs, contact Hobart Warewash Technical Support