Filter
Top Products
– 10 –
DOs AND DON'Ts FOR YOUR NEW HOBART DISHWASHER
DO assure proper water hardness of 3 grains or less per gallon.
DO pre-scrap dishes thoroughly.
DO use only detergents recommended by your chemical professional.
DO at the end of the day, thoroughly cleanse the machine, rinse, and dry (leave doors open).
DO closely follow your chemical professional's prescribed deliming schedule.
DO use only products formulated to be safe on stainless steel.
DO NOT over soften water (recommended water hardness range is 3 grains or less per gallon).
DO NOT use detergents formulated for residential dishwashers.
DO NOT allow food soil to accumulate on the tank bottom.
DO NOT exceed chemical manufacturer's recommended concentrations for detergent, rinse aid, or
lime scale remover.
DO NOT use steel wool to clean ware or dishwasher surface.
DO NOT allow foreign objects to enter the unit, especially metallic contaminants.
NOTE: Failure to follow use, care, and maintenance instructions may void your Hobart dishwasher
warranty.
CLEANING THE BLOWER-DRYER AIR FILTER
At least twice each month, the air lter
(when present, Fig. 30) on the blower-dryer
should be removed and cleaned in a sink
with warm soapy water and hosed off with
clean water. The air lter can be washed in
the dishwasher and ushed with clean water
after washing. Replacement air lters are
available — contact Hobart service.
R – L OPERATION SHOWN
Fig. 30
BLOWER-DRYER FILTER
LIFT UP AND PULL FORWARD
TO REMOVE