Filter
Top Products
— 21 —
CONVEYOR BELT ASSEMBLING AND DISASSEMBLING (Fig. 12)
Install the conveyor belt so that it always runs in
the direction indicated by this arrow — the closed
end of the loop toward the direction of travel.
The arrows in the belt illustrate the movement of
the splicing strand between steps.
When bending the splicing strand, try to limit
bending to straight portions of the strand rather
than in the "Z" bend area.
Splice one side completely before starting the
other side.
After completely splicing the belt, it is advisable to
go along the width of the belt straightening the
spliced-in strand.
Depending upon the width of the belt, there might
be one, two, or three splicing strands.
Fig. 12
2
3
4
5
6
7
1
PL-52997