Filter
Top Products
– 5 –
INSTALLATION CODES AND STANDARDS
In the United States, Hobart HHFC Series Deli Display Cases must be installed in accordance with
state and local codes and the National Electrical Code, ANSI/NFPA-70 (latest edition).
In Canada, Hobart HHFC Series Deli Display Cases must be installed in accordance with local codes
and the Canadian Electrical Code Part 1, CSA Standard C22.1 (latest edition).
ASSEMBLY
Installation of Glass Side Panels
CAUTION: Handle glass panels with care during installation to avoid breakage. The glass side
panels and front viewing glass are tempered safety glass. If the edges of the glass come in contact
with concrete, stainless steel or other hard surfaces, breakage may occur.
1. Prior to installing the side glass, it is necessary to remove the front (customer's side) stainless steel
front well cover (all models except Two Tier and Designer)
.
This is the front cover located even with
the well. To remove the front well panel, lift the front glass into the upright position. Then carefully
pull the front well panel from the case. The front well panel snaps into place. You must pull hard
to remove.
2. When installing the side glass panels, it may be necessary to lift the lighting canopy to make sure
that the side glass panel follows the track where it is intended to fit. The canopy is designed for
this in order to properly fit the glass.
3. Install one side glass panel at a time, taking care to avoid fracturing the glass. Do not slide the glass
on the stainless steel surfaces. Push the glass panels all the way back. Notice where the front glass
rests when in the down position. The front edge of the side glass panels should stop just beyond
where the front glass rests in the down position.
4. After installing the side glass panels, replace the stainless steel front well panel by snapping it in
place. Lower the front glass panel slowly so it does not hit the side glass panel edges. Once the
front glass is in the down position, move the side glass panels forward so they come as close as
possible to the front glass panel without touching it. The deli case has been specifically designed
so the side panels and front glass do not touch each other in order to avoid possible fracture.
Installation of Divider Bars
Well divider bars are supplied with each case, with the exception of Two Tier models. The long divider
bars are placed onto the divider stationary brackets located in the case well. The long divider bars run
from the front of the case (customer side) to the back of the case (operator side). The short divider bars
are placed between the long divider bars to allow the operator to use varying pan sizes in the case.
Well Divider Bars
Depending upon the model, well divider bars are provided in the quantities shown in the table.
latsedeP,oruE
rengiseDro
4CFHH:sledoM
C4CFHHro
latsedeP,oruE
rengiseDro
5CFHH:sledoM
C5CFHHro
latsedeP,oruE
rengiseDro
6CFHH:sledoM
C6CFHHro
latsedeP,oruE
rengiseDro
8CFHH:sledoM
C8CFHHro
:sledoMreiTowT
,5CFHH,4CFHH
8CFHHro6CFHH
sraBrediviDtrohS6801410
sraBrediviDgnoL23460