Hobart LX30 Dishwasher User Manual


 
– 3 –
Model LX30 Dishwasher
Installation, Operation, and Care of
LX SERIES DISHWASHERS
SAVE THESE INSTRUCTIONS
GENERAL
The LX Series dishwashers are fully automatic, front-loading
dishwashing machines which are equipped with a
3
/
4
horsepower electric motor.
All LX Series dishwashers shut down automatically four hours
after last use to conserve energy.
Standard equipment includes two 20" x 20" racks, electronic
controls, pumped drain, fill hose and drain hose.
MODEL DESCRIPTION
LX18H Washes with water from previous
rinse cycle, drains, and fills again with
fresh water for the rinse cycle. Rinse
is retained for the next wash cycle.
The LX18H has a built-in booster
heater.
LX18, LX18C Fill and drain cycle: fills, washes, drains, fills, rinses, and drains again to end
the cycle.
LX18 requires 180°F incoming water temperature.
LX18C is a low-temperature, chemical sanitizing machine for use with
5.25%
or 8.40% sodium hypochlorite solution (bleach) as the sanitizing
agent.
LX30 Fresh water rinse; requires 180°F incoming water temperature.
LX30H, LX40H
Fresh water rinse with a built-in booster heater. Normally the machine
requires 140°F incoming water and is heated in the booster to 180°F;
however, in the LX40H, a 70°F rise in temperature is available by using the
standard heavy cycle. This allows an incoming water temperature of
110°F. In
the LX30H, a 70°F rise is also possible; contact your local
Hobart Service
Office.
LX30C, LX40C Fresh water rinse; low temperature, chemical sanitizing models for use
with
5.25% or 8.40% sodium hypochlorite solution (bleach) as the
sanitizing
agent. LX30C equipped with electric booster water heater has 100°F minimum
water supply heated to 140°F with bleach as the sanitizing agent.
Water usage for the LX18 models is 2.6 gallons per rack (5.2 gallons per rack if the sump water
temperature cools between cycles); water usage for the LX30 and the LX40 models is 1.2 gallons per
rack. The machine uses 2.2 gallons per rack for the extended rinse cycle (available on LX40 models
in the heavy wash cycle only).