Hobart LX30 ML-104352 Dishwasher User Manual


 
– 13 –
Operating Models LX18, LX18C, LX18H, LX30, LX30C, and LX30H Dishwashers
DO THIS DISPLAY SHOWS REMARKS
Press ON. Model number. Dishwasher performs self check. This takes
5-10 seconds.
FILL lit and sump Dishwasher fills with water. When filled,
temperature displayed pump turns on for 10 seconds.
when machine is filling.
If door is opened during fill cycle, fill will
stop. After door is closed, the process
continues where it stopped.
FILL
flashes
when booster
is preheating on models If WASH is pressed during a fill cycle, a
LX18H and LX30H. This wash cycle will begin at end of fill cycle.
preheat could take up to
8 minutes. If beeper sounds and machine will not fill,
turn circuit breaker off, then on, and try
again. If problem persists, contact your
local Hobart Service Office.
When filled, sump When filled, machine will maintain a
temperature is displayed. READY state. Heat is maintained in both
booster and/or sump.
Open door; slide rack of Sump temperature. If your Model LX30 Series is equipped with
dishes into dishwasher the optional detergent pump, detergent will
and add detergent. be added automatically during wash cycle.
Close door.
Press WASH. WASH lit; sump tempera- Machine initiates a wash and rinse cycle.
ture displayed during If door is opened during wash cycle, cycle
wash cycle. will restart from beginning when door is
closed.
RINSE lit; rinse tempera-
If door is opened during rinse or drain cycle,
ture displayed during cycle will continue at point where door was
rinse cycle. opened upon closing door.
If OFF is pressed during cycle, machine will
drain and shut down.
When cycle is complete, Sump temperature. Machine will drain and shut down if the
reload machine for next programmed idle shutdown time is reached.
wash/rinse cycle, or, if
not in use, machine will
maintain READY mode.
At end of day, press OFF. Display shut down. When OFF key is pressed, machine will
drain and shut down.