Filter
Top Products
– 16 –
CONTROLS — Models LX40H & LX40C (Fig. 4)
Fig. 4
Operating Models LX40H & LX40C
DO THIS DISPLAY SHOWS REMARKS
Press ON. Two counts of "00000" to Dishwasher performs self check. This takes
"99999", then model 5-10 seconds.
number.
FILL displayed when Dishwasher fills with water; detergent is
machine is filling. added automatically. When filled, pump
turns on for 10 seconds.
WAIT displayed when
If WASH is pressed during a fill cycle, a wash
booster is preheating. cycle will begin at the end of the fill cycle.
This preheat could take
up to 8 minutes. If door is opened during a fill cycle, the fill
will stop. After door is closed, the process
continues where it stopped.
If beeper sounds and machine will not fill,
turn circuit breaker off, then on, and try
again. If problem persists, contact your
local Hobart Service Office.
When filled, ON lit and Machine will maintain a READY state.
READY displayed. Heat is maintained in both booster and/or
sump.
OFFON LX40
CYCLE
WASH
SELECT
PRIME
DELIME
ON
PRIME
PROGRAM
WASH
CALL SERVICE
LIGHT
NORMAL
HEAVY
DELIME
ADDRINSE AGENT
RINSE
SANITIZER
DETERGENTLOW
°F
°C
PL-52242
Models LX40H & LX40C