Hobart ML-104822 Kitchen Utensil User Manual


 
– 5 –
SLICING — MODEL 2712
With the Gauge Plate fully closed, pull the Carriage all the way toward you until it reaches its stop. With
the Meat Grip out of the way, place the product to be sliced on the Carriage Tray. Adjust the fence,
if equipped, by loosening the thumb screw and sliding the fence so that it is close to the product but
not pushing against it. Tighten the thumb screw. Set the Meat Grip against the product. Always make
sure the Lever (Fig. 3) is in the Manual position (down) before starting the slicer. Turn the slicer on
by pulling the Switch Knob (Fig. 3) forward until it starts and then releasing it.
If the Meat Grip is not needed, it may be stored out of the way by sliding it to the top of its travel, rotating
it under the Carriage Tray, and allowing it to rest in the Retaining Clip (Fig. 3).
Adjust the gauge plate by turning the Index Knob (Fig. 3) to obtain the desired slice thickness. The
numbers on the Index Knob do not indicate actual measurements but may be used for reference to
duplicate slice thickness.
Use the Carriage Tray Handle (Fig. 3) to push the Carriage back and forth to slice manually.
To operate the slicer in Automatic mode . . . Rotate the Speed Selector Knob (Fig. 3) to the desired
speed; make sure the Carriage is in H
OME position (all the way forward); make sure the Lever (Fig. 3)
is on the Manual position (pointing down); turn the slicer on; start the carriage drive unit by rotating the
Lever to the Automatic position (up and to the right).
Either of the two speed selections can be used to begin Automatic mode. The speed can be adjusted
at any time by rotating the Speed Selector Knob.
To stop the drive unit, rotate the Lever down and to the left — to the Manual position.
To use the optional Food Chute, place the Meat Grip on the Retaining Clip, fit the hangers on the Food
Chute around the meat grip slide rod (at front), and lower the Food Chute onto the Carriage Tray.
Model 2712
Fig. 3
PL-41251-1
GAUGE PLATE
TOP KNIFE
COVER
CARRIAGE TRAY
CARRIAGE TRAY HANDLE
INDEX KNOB –
SET BELOW ZERO
WHEN NOT OPERATING
LEVER IN MANUAL (DOWN) POSITION
SWITCH KNOB
SPEED SELECTOR KNOB
SHARPENER
LATCH KNOB
RETAINING CLIP
(MEAT GRIP)
MEAT GRIP HANDLE
MEAT GRIP
CARRIAGE TRAY
LOCKING KNOB
FENCE