Filter
Top Products
OV500 SERIES RACK OVEN - REMOVAL AND REPLACEMENT OF PARTS
REMOVAL AND REPLACEMENT OF PARTS
STEAM PANEL
NOTE: Hand tighten only, do not use power tools
when installing panel screws.
1. Remove screws securing steam panel to baking
compartment rear wall (through access holes).
2. Remove screws securing steam panel to left
baking compartment wall.
3. Remove screws securing steam panel to baking
compartment ceiling (left rear corner) Reverse
the procedure to install.
4. Reverse the procedure to install.
RACK ROTATOR ASSEMBLY
Removal
1. Remove rack carrier.
A. Support rack carrier.
B. Loosen set screws.
C. Remove snap ring from end of shaft.
D. Lower carrier to remove.
2. Remove rotator and lift assembly cover.
3. Remove actuator for rack up and down
switches.
4. Disconnect lead wires from rack pointer
switches, capacitor, and rotator motor.
F25361 (January 2010)Page 13 of 60