Filter
Top Products
8
INSTALLATION: «ELECTRICAL CONNECTION»
The mains electricity supply connected to the appliance should comply with the norms in
force in the country of installation.
Connection to the mains electricity supply should be through a socket with an earth
terminal, or through an intermediary switching device with a gap between contacts of
at least 3 mm.
The power supply unit must be protected by appropriate fuses and use cables of a large
enough cross section to provide a normal supply to the appliance.
The hob is fitted with a power supply cable* without plug which allow it to be connected
only to a power supply of 230 V between phases, or between phase and neutral.
• Connect to a 10/16 Amp socket. Before connecting, it is compulsory
to check :
. the power supply voltage shown on the electricity meter,
. the adjustment of the circuit breaker, and
. the fuse rating 10A.
Note : the socket must be reachable for any eventual repair. Take care of its location
at the time you install the hob.
Warning : before proceeding with the connection, check the continuity of the
earthing of the power supply unit.
We cannot be held responsible for any accident which has resulting from the use
of an appliance which is not connected to earth, or whose earthing is defective.
* The eventual replacement of the supplying cord must be carried on by the After Sales
Service or by an agreed engineer, with a cord whose characteristics must be similar to the
original one.