Filter
Top Products
3
INSTALLATION
Installing a domestic appliance can be a complicated operation which, if not carried
out correctly, can seriously affect consumer safety.
It is for this reason that the task should be undertaken by a professionally
qualified person who will carry it out in accordance with the technical regulations in
force.
In the event that this advice is ignored and the installation is carried out by an
unqualified person, HOOVER declines all responsibility for any technical failure
of the product whether or not it results in damage to goods or injury to individuals.
INSTALLATION: "BUILDING-IN"
Both the unit into which the hob will be fitted and any adjacent kitchen furniture must be
made of heat resistant material and fixed with heat resistant adhesive.
If, when installing the hob, the lower part of the casing is adjacent to an area normally
accessible when handling or cleaning, fit a heatproof partition 1 cm below the base of
the casing, with a 10x10 cm opening in the rear right-hand corner, to avoid any risk of
burning or damage.
There should also be a 5 cm gap between the appliance and all adjacent vertical
surfaces.
A foam adhesive seal is supplied with the hob. Stick this seal under the edge of the body
as near as possible to the outer edge of the hob. Press round the edges of the hob,
so that the seal flattens out and ensures an air tight seal.
Fitting the seal
Top view of the hob
SEAL