Filter
Top Products
05 GB
The drip tray catches the juices from grilled foods. It is only used with the Grill, Rotisserie, or Fan Assisted Grill ;
remove it from the oven for other cooking methods.
Never use the drip tray as a roasting tray as this creates smoke and fat will spatter your oven making it dirty.
The pizza set is designed for pizza cooking. In
order to obtain the best results the set must be
used together with Pizza function.
The tray holder
The tray holder shelf is ideal for grilling.
Use it in conjunction with the drip tray. A
handle is included to assist in moving
the both accessories safely. Do no
leave the handle inside the oven.
2. USEFUL TIPS
2.1 SHELF SAFETY SYSTEM
The oven features a new shelf safety
system.
This allows you to pull out the oven shelves
when inspecting the food without danger of
food spillages or shelves falling
accidentally out of the oven.
To remove the shelves pull out and lift.
2.2 GRILLING
Grilling makes it possible to give food a rich brown colour quickly. For
browning we recommend that you insert the grill onto the fourth level,
depending on the proportions of the food (see fig. page 08).
Almost all food can be cooked under the grill except for very lean game
and meat rolls.
Meat and fish that are going to be grilled should first be lightly doused
with oil.
For recommended cooking times and temperatures the first time you
use the oven, refer to the tables on pages 08, 09. You may then wish to
vary these times and settings in the light of your own experience.
2.3 COOKING TIME
2.5 HYDRO EASY CLEAN FUNCTION
The HYDRO EASY CLEAN procedure uses steam to help remove
remaining fat and food particles from the oven.
1. Pour 300 ml of water into the HYDRO EASY CLEAN container at
the bottom of the oven.
2. Set the oven function to Static ( )or Bottom ( )heater
3. Set the temperature to the HYDRO EASY CLEAN icon
4. Allow the program to operate for 30 minutes.
5. After 30 minutes switch off the program and allow the oven to
cool down.
6. When the appliance is cool, clean the inner surfaces of the oven
with a cloth.
Warning
Make sure that the appliance is cool before you touch it.
Care must be taken with all hot surfaces as there is a risk of burns.
Use distilled or drinkable water.
2.4 CLEANING AND MAINTENANCE
Clean the stainless steel and enamelled surfaces with warm, soapy
water or with suitable brand products. On no account use abrasive
powders that may damage surfaces and ruin the oven’s appearance.
It is very important to clean the oven each time that it is used. Melted
fat is deposited on the sides of the oven during cooking. The next time
the oven is used this fat could cause unpleasant odours and might
even jeopardise the success of the cooking. Use hot water and
detergent to clean; rinse out thoroughly.
To make this chore unnecessary all models can be lined with catalytic
self-cleaning panels: these are supplied as an optional extra (see the
section SELF-CLEANING OVEN WITH CATALYTIC LINING).
Use detergents and abrasive metal pads like «brillo pads» for the
stainless steel grills.
The glass surfaces as the top, oven door and warming compartment
door must be cleaned when they are cold. Damage that occurs to
them because this rule was not adhered to are not covered by the
guarantee.
To replace the interior light:
. switch off the mains power supply and unscrew bulb. Replace with an
identical bulb that can withstand very high temperatures
2.6 SERVICE CENTRE
Before calling the Service Centre
If the oven is not working, we recommend that:
you check that the oven is properly plugged into the power supply.
If the cause of the fault cannot be detected:
disconnect the oven from the mains, do not touch the oven and call the
after sales service.
Before calling the Service Centre remember to make a note of the
serial number on the specifications plate (see fig. On last page).
The oven is supplied with a guarantee certificate that ensures that it
will be repaired free of charge by the Service Centre
300 ml
1.8 Removing and cleaning wiıre racks
1- Remove the knurled nuts by turning them counter clockwise.
2- Remove the wire racks by pulling them towards yourself.
3- To clean the wire racks either put them in the dishwasher or use a wet sponge, ensuring that they are
dried afterwards.
4- After the cleaning process install the wire racks in reverse
order.
5- Replace the knurled nuts.
A