Filter
Top Products
40
B. Important Notes for Component Replacement
CAUTION
When replacing a component listed below, see the notes to help ensure proper
operation.
Component Notes
Compressor Install a new start relay, start capacitor, and compressor overload (compressor overload
is integrated with the start relay on refrigerators; internal on 1-section freezers; external on
2-section freezers).
Compressor,
Evaporator
Fan Motor,
Condenser Fan
Motor
WARNING! To reduce the risk of electric shock, be sure to reconnect the
component's ground wire.
Expansion Valve •Attachtheexpansionvalvebulbtothesuctionlineinthesamelocationastheprevious
bulb.
•Securethebulbwiththeclampandholder,theninsulateit.
Defrost
Thermistor
After working with or around the defrost thermistor on a freezer, make sure the defrost
thermistor wire is not touching the defrost heater.
Control Module If three dashes (- - -) appear on the display module when energized, the compressor and
display module are off. To turn the compressor and display module on, press and hold
the upper and lower buttons until the temperature appears on the display. CAUTION! The
three dashes must be cleared, otherwise the compressor will not run and product
will be lost.
C. Door Re-Hinging
This unit is provided with a cabinet design which, after being delivered to the installation
location, permits changing of the door swing from left to right or right to left. To change
the door swing, an HS kit from your local Hoshizaki distributor is required. See the table
below. CAUTION! Improper installation of the HS kit may result in the doors not
closing completely and/or the gaskets not sealing correctly. For further details,
contact your local Hoshizaki distributor or Hoshizaki Technical Support at
1-800-233-1940.
Convert HS Kit Number
Right Hinge to Left Hinge HS-3725
Left Hinge to Right Hinge HS-3726