Filter
Top Products
14
[b] STORAGE BIN, SLOPE, SCOOP, ETC.
IMPORTANT
1. Wash your hands before removing ice. Use the Plastic Scoop provided to
remove ice.
2. Keep the Scoop clean. Clean it by using a neutral cleaner at least once a
day, and rinse thoroughly.
3. Close the Bin Door after removing ice to prevent entrance of dirt, dust or
insects into the Bin.
4. Clean the Bin Liner at least once a month by using a neutral cleaner. Rinse
thoroughly after cleaning.
5. The Storage Bin is for ice use only. Do not store anything else in the Bin.
6. Keep the area around the icemaker clean. Dirt, dust or insects in the icemaker
could cause electrical damage to the equipment or harm to individuals.
1) Remove the Front Panel (Lower), and move the Control Switch on the Control Box to the
“OFF” position.
2) Unplug the icemaker.
3) Open the Bin Door, and remove ice from the Storage Bin.
4) Remove the Slope by bending its center carefully and releasing it from the two Slope
Shafts. Take out the Slope from the Storage Bin.
5) Thoroughly clean and sanitize the Storage Bin, Slope, Scoop and any parts normally
accessible from the Storage Bin.
6) Remove each Separator by lifting it to the
horizontal position and pushing it hard inward.
Remove all the Separators in the same way,
and clean and sanitize them.
7) Disconnect the Suction Tube from the Water
Tank to drain the Tank.
Water Tank
Suction Tube
Separator