Hoshizaki AM-100BAE Ice Maker User Manual


 
4
II. INSTALLATION AND OPERATING INSTRUCTIONS
1. CHECKS BEFORE INSTALLATION
* Visually inspect the exterior of the shipping container, and any severe damage noted should
be reported to the carrier.
WARNING
1. Remove shipping tape(s) and packing as follows. If any left in the icemaker,
it will not work properly.
2. Do not lift or carry the unpacked icemaker by using the brass fitting for water
supply at the rear of the unit. The plastic threads may be damaged.
IMPORTANT
1. Remove the shipping tapes holding the Door and Separator.
2. Ensure all components, fasteners and thumbscrews are securely in place.
* Remove the package containing accessories.
* Check that refrigerant lines do not rub or touch lines or other surfaces.
* Check that the Compressor is snug on all mounting pads.
* See the Nameplate on the upper right part of the Left Side Panel, and check that your
voltage supplied corresponds with the voltage specified on the Nameplate.
Fig. 1
Ice Making Mechanism
Separator
Shipping Tape
Door
Shipping Tape
Nameplate
Accessories
Compressor
Mounting Pad