Hoshizaki DCM-751BAH(-OS) Ice Maker User Manual


 
26
8) Allow the icemaker to sit for 10 minutes before operation. If you placed a clamp on the
reservoir hose in step 6, remove it before operation.
9) In bad or severe water conditions, clean the oat switch assembly as described below.
Otherwise, continue to step 10.
a. Remove the oat switch assembly from the reservoir cover.
b. Wipe down the oat switch assembly with the cleaning solution.
c. Rinse the oat switch assembly thoroughly with clean water.
d. Replace the oat switch assembly in its correct position.
10)Movethepowerswitchtothe"ON"positionandreplacethepanelsintheircorrect
positions.Turnonthepowersupply,thenmovethecontrolswitchtothe"ICE"position.
Make ice using the solution until the icemaker stops making ice.
Note: This unit will not run if the safety switch is not engaged.
11)Movethecontrolswitchtothe"OFF"position,pausemomentarily,thenmovetothe
"DRAIN"position.Allowthewatersystemtodrainfor5minutes.
12)Movethecontrolswitchtothe"OFF"position,pausemomentarily,thenmovetothe
"ICE"position.Opentheicemakerwatersupplylineshut-offvalvetosupplywatertothe
reservoir.
13)Afterthegearmotorstarts,movethecontrolswitchtothe"OFF"position,pause
momentarily,thenmovetothe"DRAIN"position.Allowthewatersystemtodrainfor
5minutes.
Note:Ifyoudonotsanitizetheunit,movethecontrolswitchtothe"OFF"position,
pausemomentarily,thenmovetothe"ICE"positionafterthewatersystem
drains. Allow the icemaker to run for 30 minutes, then move the control switch to
the"OFF"position.Turnoffthepowersupply,thenremovethefrontpaneland
storagebincover.Movethepowerswitchtothe"OFF"position.Gotostep12in
"III.A.2.c)CleaningandSanitizingProcedure"under"DispensingComponents."
14)Movethecontrolswitchtothe"OFF"position,thenturnoffthepowersupply.
15) Close the icemaker water supply line shut-off valve.