Filter
Top Products
31
7) Immerse the parts removed in the above steps 2) through 6) in the cleaning and
sanitizing solution for about 15 minutes each.
8) Rinse these parts thoroughly with clean water.
9) Wipe thoroughly the Shutter located above the Ice Dispensing Spout.
10) Reassemble the Bin Control Bracket Assembly.
11) Place the Dispensing Auger and Agitator, Bin Control Bracket Assembly, Spout-Bin,
Spout Gasket-Bin, black Ice Dispensing Spout, Water Dispensing Nozzle and Spout
Cover (on models DCM-750BAF and BWF, also the Ice Guide and the Drain Pipe)
back in position.
12) Pour warm water into the Storage Bin to melt the ice produced from the cleaning
and sanitizing solution.
13) Clean the storage bin liner, and rinse thoroughly.
14) Place the Front Cover of the Storage Bin, the Top Panel and the Front Panel back
in position.
6. Remove the Spout Cover and, the black Ice Dispensing Spout and the Water
Dispensing Nozzle. See Fig. 16.
Fig. 16Fig. 16
Fig. 16Fig. 16
Fig. 16