Filter
Top Products
7
C. Location
CAUTION
This icemaker is not intended for outdoor use. Normal operating ambient
temperature should be within +45°F to +100°F (+7°C to +38°C); Normal
operating water temperature should be within +45°F to +90°F (+7°C to +3°C).
Operation of the icemaker, for extended periods, outside of these normal
temperature ranges may affect icemaker performance.
For best operating results:
• Icemaker should not be located next to ovens, grills or other high heat producing
equipment.
• Location should
provide a rm and level foundation for the equipment.
• Allow 4" (61 cm) clearance at top to allow for removal of the auger and for ease of
maintenance and/or service should they be required.
D. Setup
1) Attach the four adjustable legs provided to the bottom of the icemaker.
) Position the icemaker in the selected permanent location.
3) Level the icemaker from side-to-side and front-to-rear by adjusting the legs.
E. Electrical Connection
WARNING
The GREEN ground wire in the factory-installed power cord is connected
to a screw on the bracket where the cord enters the machine. If it becomes
necessary to remove or replace the power cord, be sure to connect the power
cord's ground wire to this screw upon reattachment.
• Electrical connections must be installed in accordance with applicable national, state
and local regulations.
• The unit requires an independent power supply. See the nameplate for proper voltage
and breaker/fuse size.
• Usually an electrical permit and services of a licensed electrician are required.
F. Water Supply and Drain Connections
• Water supply inlet is 1/" female pipe thread (FPT).
• A water supply line shut-off valve and drain valve must be installed. A minimum of
3/8" OD copper tubing is recommended for the water supply lines.
• Water supply pressure should be a minimum of 10 PSIG and a maximum of 113 PSIG.
If the pressure exceeds 113 PSIG, the use of a pressure reducing valve is required.
• Drain outlet is 3/4" FPT.
• Drain line must have 1/4" fall per foot ( cm per 1 m) on horizontal runs to get good
ow. A vented tee connection is also required for proper ow.