Filter
Top Products
16
8. FINAL CHECK LIST
1) Is the icemaker level?
2) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F all year
around?
3) Is there at least a 6" clearance around the icemaker for maintenance or service?
4) Have all shipping tape(s), packing and cartons been removed from the icemaker? Are
the cube guides in their correct position? Are the separators properly attached to their
holding clips?
5) Have all electrical and piping connections been made?
6) Has the power supply voltage been checked or tested against the nameplate rating?
And has a proper ground been installed in the icemaker?
7) Are the Water Supply Line Shut-off Valve and Drain Valve installed? Has the water
supply pressure been checked to ensure a minimum of 10 PSIG and a maximum of 113
PSIG?
Note: The icemaker may stop running when the water supply is OFF, or if the pressure
is below 10 PSIG. When the proper water pressure is reached, the icemaker
automatically starts running again.
8) Have the compressor hold-down bolts and refrigerant lines been checked against
vibration and possible failure?
9) Has the Bin Control Assembly been checked for correct operation? During the first five
minutes of the freeze cycle, hold an ice cube in contact with the face of the sensor
housing. The icemaker should stop within 3 to 5 seconds.
Note: The ice machine will only shut off during the first five minutes of the freeze cycle.
10) Has the end user been given the instruction manual, and instructed on how to operate
the icemaker and the importance of the recommended periodic maintenance?
11) Has the end user been given the name and telephone number of an authorized service
agent?
12) Has the warranty tag been filled out and forwarded to the factory for warranty
registration?