Filter
Top Products
52
16) Connect the terminals, and replace the terminal cover in its correct position.
17) Replace the panels in their correct positions.
18) Turn on the power supply.
4. Removal and Replacement of Drier
IMPORTANT
Always install a new drier every time the sealed refrigeration system is opened. Do not
replace the drier until after all other repair or replacement has been made.
1) Turn off the power supply.
2) Remove the panels.
3) Recover the refrigerant and store it in an approved container.
4) Remove the drier.
5) Install the new drier with the arrow on the drier in the direction of the refrigerant flow. Use
nitrogen gas at a pressure of 3 - 4 PSIG when brazing the tubings.
6) Check for leaks using nitrogen gas (140 PSIG) and soap bubbles.
7) Evacuate the system and charge it with refrigerant. For air-cooled and water-cooled models, see
the nameplate for the required refrigerant charge. For remote air-cooled models, see the charge
label in the machine compartment.
8) Replace the panels in their correct positions.
9) Turn on the power supply.