Hoshizaki KM-1601MRH/3 Ice Maker User Manual


  Open as PDF
of 50
 
49
B. Maintenance
IMPORTANT
This icemaker must be maintained individually, referring to the instruction
manual and labels provided with the icemaker.
1. Stainless Steel Exterior
To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a
damp cloth containing a neutral cleaner to wipe off oil or dirt build up.
2. Storage Bin and Scoop
•Washyourhandsbeforeremovingice.Usetheplasticscoopprovided.
•Thestoragebinisforiceuseonly.Donotstoreanythingelseinthebin.
•Keepthescoopclean.Cleanitbyusinganeutralcleanerandrinsethoroughly.
•Cleanthebinlinerbyusinganeutralcleaner.Rinsethoroughlyaftercleaning.
3. Condenser
Check the condenser once a year, and clean if required by using a brush or vacuum
cleaner. More frequent cleaning may be required depending on the location of the
condenser unit.
C. Preparing the Icemaker for Long Storage
WARNING
When shutting off the icemaker for an extended time, drain out all water from
the water tank and remove the ice from the storage bin. The storage bin should
be cleaned and dried. Drain the icemaker to prevent damage to the water
supply line at subfreezing temperatures, using air or carbon dioxide. Shut off
the icemaker until the proper ambient temperature is resumed.
Note: When the icemaker is not used for two or three days, it is sufficient to only
movethecontrolswitchtothe"OFF"position,unlesstheicemakerwillbeat
subfreezing temperatures.
1. Remove the water from the potable water supply line:
1) Remove the front panel.
2)Movethecontrolswitch(onthecontrolbox)tothe"OFF"position.
3) Wait 3 minutes.
4) Close the potable water supply line shut-off valve and open the potable water supply
line drain valve.
5) Allow the line to drain by gravity.
 previous