Filter
Top Products
13
II. Installation and Operating Instructions
A. Checks Before Installation
IMPORTANT
1. Remove all shipping cartons, tape and packing. If packing material is left in
the icemaker, it will not work properly.
2. Ensure all components, fasteners and thumbscrews are securely in place.
• Remove the panels to prevent damage when installing the icemaker. (See "B. How to
Remove Panels.")
• Remove the package containing the accessories from the compressor compartment.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied
corresponds with the voltage specified on the nameplate.
• This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE
STORAGE BIN, Model B-800 series.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the two screws. Lift up and pull
towards you.
• Top Panel: Remove the two screws, and then lift off.
• Side Panel (R): Remove the screw. Pull slightly
towards you, and take off.
• Insulation Panel: Remove the thumbscrew. Lift up
slightly, and pull towards you.
Fig. 1