![](http://pdfasset.owneriq.net/7/cb/7cb5e125-a2ae-4bee-8c81-73391b7fdf0f/7cb5e125-a2ae-4bee-8c81-73391b7fdf0f-bg10.png)
16
(Control Products HOS-001A Board)
to the K1 connector. If there is a white wire, place the switch in the C position. If this
switch is placed in the wrong position either the compressor contactor will remain ener-
gized with the control switch OFF or the unit will not start.
The dip switches should be adjusted per the adjustment chart published in the Tech
Specs book. 7 & 8 must remain in the OFF position.