Filter
Top Products
77
Note: To remove cubes on the evaporator, turn off the power supply and turn it back
on after 3 minutes. The defrost cycle starts and the cubes will be removed from
the evaporator.
3) Turn off the power supply.
4) Remove the front panel. Then remove the insulation panel by removing thumbscrew,
lifting up the panel slightly and pulling it toward you. Remove cube guide B by removing
thumbscrew. Remove cube guide A. Remove overflow cap, overflow pipe, and water
shield.
5) Remove the drain plug located inside the water tank. Drain the water tank. Replace the
drain plug in its correct position.
6) Pour the cleaning solution into the water tank.
7) Fully open the cleaning valve on the left side wall of the machine compartment.
8) Move the control switch on the control box to the “WASH” position.
9) Replace water shield, overflow pipe, overflow cap, cube guide A, cube guide B, and
insulation panel in their correct positions. Replace the front panel in its correct
position.
10) Turn on the power supply, and start the washing process.
11) Turn off the power supply after 30 minutes.
12) Remove the front panel.
13) Remove the insulation panel by removing thumbscrew, lifting up the panel slightly and
pulling it toward you. Remove cube guide B by removing thumbscrew. Remove cube
guide A. Remove overflow cap, overflow pipe, and water shield.
14) Remove the drain plug located inside the water tank. Drain the water tank. Replace the
drain plug in its correct position.
15) Replace water shield, overflow pipe, overflow cap, cube guide A, cube guide B, and
insulation panel in their correct positions.
16) Move the control switch to the “ICE” position.
17) Close the cleaning valve.
18) Replace the front panel in its correct position.