Filter
Top Products
40
Care and Cleaning
(DQ47 & DE47X1)
CLEANING THE DOORS
Take particular care not to damage the inner surface of the door inner glass that is
coated with a heat reflective layer. Do not use scouring pads, or abrasive powder,
which will scratch the glass.
Ensure that the glass panel is not subjected to any sharp mechanical blows.
Stubborn stains can be removed by using a fine steel wool soap pad.
For slight soiling the
inner glass panel may be cleaned, while still warm, without removing it from the door. After
cleaning, rinse and dry with a soft cloth.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and remove the extrusion top filler cap. (This should be done
by pressing both release clips, one on each side of the door - see below pic, then
simply lift the inner glass out of position).
NOTE: If you need to use a tool - be careful not to damage the extrusion or end cap.
2. Carefully slide the inner glass towards you and
withdraw it from its locating slots. Ensure
that the door is not allowed to slam shut, due
to the reduction in door weight.
Clean the glass as described above.
3. The inside of the outer door glass can now be
cleaned while still fitted to the cooker.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1. Open the door fully.
2. Locate the inner door glass into its slots, so that the printing is readable from
the face nearest the oven in the closed position and the widest black band is
towards the bottom of the door. The inner door glass has a special reflective
coating on one side, in order to minimise surface temperatures and energy
consumption during use, it is important it is fitted correctly.
3. Carefully slide the glass into its slots as far as it will go and replace the top
filler cap.
Top filler cap
Press both release clips
to remove top filler cap