Filter
Top Products
6
D
ISHWASHER
Getting to know your Dishwasher
Technical Characteristics
The Controls
E. Upper basket
F. Top spray arm
G. Basket height adjuster
H. Lower basket
I. Bottom spray arm
J. Salt container cap
K. Washing filter
L. Detergent and rinse aid
dispenser
This dishwasher conforms to the
following European Community
Directives:
73/23/EEC of 19/02/73 (Low
Voltage) and subsequent
modifications;
89/336/EEC of 03/05/89
(Electromagnetic
Compatibility) and subsequent
modifications;
97/17/CE
(Labelling)
02/96/CE
(Waste Electrical
and Electronic
Equipment)
Technical characteristics
Width cm. 59,5
Depth cm. 57
Height cm. 82
Capacity 12 standard place settings
Mains water pressure 4,3 psi - 145 psi (30 KPa÷ 1MPa) (0,3 ÷10 bar)
Power voltage See data plate
Total absorber power See data plate
Fuse See data plate
A
B
M
C
D
R
A. ON-OFF Button
Press this button to turn the
appliance on.
B. ON-OFF Indicator light
Indicates that the appliance is
turned on
C. Door opening handle
Use this handle to open the
dishwasher door.
D. Display (LCD)
Buttons and indicator lights to
program the appliance.
G. Cycle phase indicator light
(pre-wash, wash, rinses, drying)
H. Extra drying button
Press this button for greater
drying
I. Delayed start select button
This button delays the start of
the wash cycle you selected by
1 to 24 hours.
L. Multifunction numeric
indicator
It informs you as to: the
duration of the cycle, the
amount of time left to wait and
any error codes.
M. Cycle selection knob
Turn it to select the desired
wash cycle.
N. Half load selection button
To allow you to wash a half-
load on the upper rack.
R. Start/Reset Button
With Start, the wash cycle
begins, whereas all the settings
are cleared with Reset.
S. Low salt indicator light
This light warns you that it is
time to add more salt.
T. Low rinse aid indicator light
This light warns you that it is
time to add more rinse aid.
U. Delayed start indicator light
This indicates that the
delayed start has been set
V. Half load indicator light
To indicate that the half loading has
been set.
Z. Extra drying indicator light
To indicate that the extra drying
has been set.