Filter
Top Products
Spray arms.
Lime and remnants of food in the washing
water can block the nozzles in the spray arms
and the arm mountings.
- Inspect the nozzles in the spray arms
for blocked holes due to remnants of
food.
- If necessary,pull the lower arm
upwards and lift it off.
- Unscrew the upper spray arm.
Clean both spay arms under running
water.
- Re-fit the spray arms.Ensure that the
lower arm has locked into place and
the upper one is screwed tight.
Protection from freezing temperatures.
If the appliance is installed in a location where
there is a risk of freezing temperatures (eg.in
a holiday home),all water must be completely
drained out of the interior.
Turn OFF the tap,disconnect the supply hose
and allow to drain.
Disconnecting the Dishwasher...
When disconnecting the appliance it is
important that tasks are carried out in the
correct sequence:
- Switch off at the mains and remove
the plug from the socket.
- Turn off the water supply.
- Disconnect drain and water input
hoses.
- Remove screws in underside of work
surface.
- Pull out the appliance,carefully,
withdrawing hoses at the same time.
Transporting the Dishwasher...
Drain water from the dishwasher.Secure all
loose parts.The dishwasher should only be
transported in an upright position.
If not kept upright during transport,any
water remaining inside,may seep into the
control module and cause subsequent
errors with programme functions.
(DWF35/34 only)
The appliance must be drained in the
following sequence:
- Turn on the tap.
- Set the mains switch 1 to ON.
- Select the Economy 50˚ button.The
programme duration in minutes is
shown in the numerical display.
- Wait for approx.4 minutes.
- Terminate the programme by pressing
the Programme End buttons 11
simultaneously.
- The time display changes to 0.
- Wait a further minute and then switch
the dishwasher OFF.
- Turn off the tap.
Care and Maintenance...
22
FP105-01 DWF35/34/33/30 12/02/2002 10:23 am Page 22