Filter
Top Products
Installation...
4
Follow the Installation Instructions,making
sure the Dishwasher is correctly installed.
When installing the Dishwasher, carry out
tasks in the following order:
- choose a location.
- level the appliance (adjusting the feet).
- connect to a drainage system.
- connect inlet hose to water supply.
CHOOSE A LOCATION...
The choice of location for your appliance
will influence its performance.
●
Position where possible on a solid floor.
Vibration may occur with a wooden
floor.
●
Take care with vinyl floor coverings.The
weight of the appliance may cause
indentations in some vinyl floor cover-
ings.
●
For your safety and to comply with IEE
regulations,you should not install your
appliance in a bath or shower room.
Seek professional advice if you wish to
do so.
●
Ensure sufficient space is allowed for the
appliance.
●
Ensure the electrical socket and water
taps are easily accessible and that the
water supply can be isolated if neces-
sary.Do not use an extension lead or
multiple plug for connection to the elec-
trical socket.
●
If your dishwasher is underneath a
work surface with a hob.You must
add thermal insulation to the top of the
machine.
ADJUST THE FEET...
It is essential that the door is closed and
latched before stabilising the dishwasher.
Ensure that the rear feet are adjusted so
that the product is not sitting on the base
of the machine.Adjust either clockwise or
anti-clockwise as necessary to level.
Then adjust either of the two front feet
clockwise or anti-clockwise as necessary
until all feet are in contact with the floor to
avoid the machine from rocking and is level
to within 2˚
The door must be aligned centrally with the
sides of the cabinet to ensure the door seal
is correctly located.
Note: If the appliance is not stabilised the
door may be off centre and make the
machine unstable.