Hotpoint EG52 Electric Pressure Cooker User Manual


 
Switch off the electricity supply and allow to cool before cleaning the cooker.
Clean the cooker regularly and wipe up spills soon after they occur to prevent
them from becoming burnt on.Never use biological washing powder, caustic
cleaners,harsh abrasives,scouring pads, steam cleaners,aerosol cleaners or oven
chemical cleaners of any kind.
Before moving your cooker ensure that it is cool and note that it is heavy
(approximately 70 kg 155 lbs),so you may require assistance.To move the cooker
forward,open the top oven/grill door and with both hands positioned under the roof
of the compartment, lift and pull forward.Replace by pushing the cooker backwards.
Check that the cooker is level.Take care to ensure that any floor covering is not
damaged.
OVEN HEAT CLEAN LININGS
The oven side linings are coated with a special enamel which has a continuous
cleaning action.The higher the oven temperature the more effective the action. In
most cases this cleaning operation will proceed during normal cooking.However, if
roasting is done frequently, or high temperatures are not used regularly,it may be
necessary to run the oven empty at maximum setting for about two hours.
It should not normally be necessary to clean the linings with water, but if desired,wipe
them over with a soapy cloth,followed by a wipe with a damp clean cloth.
REPLACEMENT OF OVEN LIGHT BULB
CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE
REPLACING THE LAMP TO AVOID THE POSSIBILITY OF AN ELECTRIC SHOCK
Light bulbs are not covered by the manufacturer’s guarantee.
A new 15W,300
o
C rated SES bulb can be obtained from your cooker supplier or any
major electrical retailer.
1. Remove the shelves from the oven.
2. Unscrew the lens using a thick cloth to protect your fingers in the unlikely
event of a lens fracture.
3. Unscrew bulb.
4. Fit new bulb and refit lens.
CARE AND CLEANING
14