Filter
Top Products
Door Reversal
20
Door Handle Reversal (model FFA75 only):
12. Remove the hole plugs from the right hand side of the door.
13. Unscrew the handle fixing screws and carefully remove the handle from the
door.
14. Turn the handle vertically, top to bottom and place against the right hand
side.
15. Secure the handle in place with the original fixing screw.
16. Use the hole plugs removed from the right hand side to fill the holes on the
left.
Note : You may require assistance to do this:
10. Using the packaging from the appliance or a suitable substitute to support
the back of the appliance.Lay the appliance on it’s back ensuring the
pipework at the back is not damaged or bent.Be careful that the appliance
does not run away from you when the wheels touch the floor.
11. Unscrew the foot and hinge bracket fitted to the bottom right hand side of
the appliance.Unscrew the foot and footplate fitted to the bottom left hand
side of the appliance.
Refit the hinge bracket and the footplate to the opposite sides of the
appliance.Screw in the feet until there is approximately 35mm projecting
from the bottom front edge of the appliance.
Lift the appliance onto it’s feet. You may require assistance to do this:
Lift the appliance from the rear of the tabletop and stand it on it’s feet and
wheels.Be careful that the appliance does not run away from you when
the wheels touch the floor.
Refit the spacing washers.
CLEANING &
MAINTENANCE
Refit Lower Door
17. Take off the two screw covers from the left hand centre panel and remove
the two screws. Fit these screws and covers over on the right hand side.
18. Fit the centre hinge on the left hand side with the original screws,cover the
screws with the original covers.
19. Using a thin blunt instrument,remove the hinge
bush cap from the top left of the lower door and fit
on the top right.
Note : You may require assistance to do this:
20. Place the lower door onto the lower hinge pin.
21. Offer the door up to the centre hinge.
Put the hinge pin through the centre hinge and
ensure it locates into the door. Check that the hinge
pin is positioned the right way up.