Hotpoint FFA90 Refrigerator User Manual


 
continued...
Refit Lower Door
17. Screw the bottom hinge pin complete with spacing washers into the left hinge
bracket.
18. Take off the two screw covers from the left hand centre panel and remove the two screws.
Fit these screws and covers over on the right hand side.
19. Fit the centre hinge on the left hand side with the original screws and cover the screws with
the original covers.
20. Using a thin blunt instrument, remove the hinge bush cap from the top
left of the lower door and fit on the top right.
Note : You may require assistance to do this:
21. Place the lower door onto the lower hinge pin.
22. Offer the door up to the centre hinge and ensure it locates into the door.
Check that the hinge pin is positioned the right way up.
Refit Top Door
23. Using a thin blunt instrument, remove the hinge bush cap from the top
left of the door and refit on the top right.
24. Replace the spacing washers onto the centre hinge bracket.
Note : You may require assistance to do this:
25. Place the top hinge onto the top left of the door, slide the door onto the centre
hinge pin. Support the door while screwing the top hinge into position.
Ensure that the hinge bracket locates correctly.
26. If necessary, slacken off the screws on the centre hinge pin and adjust the doors so that they
line up with the cabinet.
27. Adjust the front feet (see ‘Levelling’ SAFETY & INSTALLATION section).
28. Fit the bottom hinge covers (see ‘Hinge Covers’ SAFETY & INSTALLATION section).
Note : Let the appliance stand upright in it’s final location for at least 15 minutes before
plugging in and switching on the electricity supply.
Door Reversal
18
CLEANING &
MAINTENANCE