Filter
Top Products
9GB
CARE AND CLEANING
Before cleaning your cooker hood or carry out any
maintenance, switch off and remove the plug from
the socket to disconnect it from the electricity
supply.
GREASE FILTERS: CLEANING METAL SELF- SUPPORTING GREASE FILTERS
The filters must be cleaned every 2 months of
operation, or more frequently with heavy usage,
and can be washed in a dishwasher.
• Remove the filters one at a time by pushing
them towards the back and pulling down at the
same time.
• Wash the filters, taking care not to bend them.
Allow them to dry before refitting.
• When refitting the filters, make sure that the
handle is visible on the outside.
CHARCOAL FILTER: REPLACING THE ACTIVATED CHARCOAL FILTER
This filter is
not washable and must be replaced
after every 4 months of operation, or more
frequently with heavy usage.
• Remove the metal grease filters.
• Remove the saturated activated carbon filter by
releasing the fixing hooks.
• Dispose of the carbon filter.
• Fit the new filter by hooking it into its housing
• Replace the metal grease filters.
LIGHT REPLACEMENT
20W halogen bulb.
• Remove the two screws fixing the lighting
support, and pull it out of from the Hood.
• Remove the bulb from the support.
• Replace with another of the same type, making
sure that the two pins are properly inserted in
the bulb holder socket holes.
• Replace the support, fixing it in place with the
two screws removed as above.
CLEANING
• Clean with a sponge soaked in warm water and
a sodium bicarbonate solution, which is among
other things a good disinfectant. If you do not
have any, you can use a neutral soap.
• DO NOT use abrasive detergents, bleach or
detergents using ammonia. NEVER use solvent
based products.
Failure to carry out the basic standards of cleaning and replacement of the filters could cause a fire
risk. Therefore you must observe these instructions.