Filter
Top Products
How to operate your
&hwasher
Door Latch
Cycle Indicator Dial
(Locked)
(Turn to Start)
I
I
(
)
STEP 1.
Load your dishwasher
with dishes, silverware, pots, pans,
bowls, etc. according to instructions
on pages 8 and 9.
STEP 2.
Add detergent to the
detergent dispenser. Make sure the
Cycle Indicator Dial is at OFF
position before adding detergent.
(See pages 6 and 7.)
Use rinse aid agent to help prevent
spotting. (See page 6.)
STEP 3.
Select DRYING HEAT
option. It must be ON for PLATE
WARMER cycle, OFF for RINSE
HOLD cycle. It can be ON or OFF,
at your option (see below), for any
of the wash cycles.
DRYING HEAT
ON
OFF
ON: Turns the drying heater on for
fast drying.
OFF:
Turns the drying heater off
to save energy. Dishes will dry
naturally over a longer period such
as overnight.
If you need your dishes sooner,
open the dishwasher door after the
cycle is complete to reduce the
natural drying time.
Use of this option reduces the
electrical energy used by this model
approximately 8% for the NORMAL
WASH cycle.
STEP 4.
Select WATER
TEMP
BOOST option.
WATER
TEMP
BOOST
ON
OFF
ON: The wash cycle will extend for
approximately 9 minutes while the
dishwasher automatically heats the
water for good washing.
Note: The temperature of the
entering water must beat least
UO°F.
for this option to work effectively
and boost the water temperature to
a good washing temperature of
140°F.
OFF:
Select this option when the
entering water temperature is
140°F.
or higher.
See How to Test Water Temperature
on page 6.
STEP 5.
Select the cycle and start
the dishwasher.
If your dishwasher drains into a
food waste disposer, operate the
disposer until it is empty before
starting the dishwasher. (See Cycle
Selection Hints on page 5.)
To obtain the benefits of a complete
cycle, be careful that you
do not
turn the dial any further than
necessary
to start the dishwasher.
Q
For POTS & PANS, NORMAL
WASH and
LIGHT
WASH cycles:
POTS NORMAL
LIGHT
PANS
WASH WASH
a. Push selected cycle button.
b. Latch the door.
ON
●
OFF
●
@
●
RINSE & HOLD
●
ORYING
●
ORYPLATE
WARMER
c.
Slowly turn Cycle Indicator Dial
to ON position to start the cycle.
You will hear the motor start.
There is a time delay between
start-up
and
water
fill
so you will
not hear any wash action right
away.
Q
For RINSE HOLD cycle:
a. Be sure door is unlatched.
b. Select DRYING HEAT-OFF
drying option.
I
ON
●
OFF
●
@
●
RINSE & HOLD
●
DRYING
●
ORYIPLATE
WARMER
I
c. Slowly turn Cycle Indicator
Dial to RINSE HOLD position.
d. Latch the door to start the cycle.
4