12
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Replacing the bulbs
Disconnect the unit from the mains and remove the grease
lter.
Caution! Make sure the bulbs are cool before touching
them.
1. Extract the guard by prising
itoutwithasmallathead
screwdriver or something
similar.
2. Replace the faulty bulb.
Use only bulbs of the
same type (for details,
see the technical data in
the following manual).
3.Rettheguard(pushitin).
Replacing the lights LED *
ThehoodisttedwithalightingsystembasedonLED
technology. The LEDs ensure optimal lighting, longer life
and lower consumption compared with traditional lights. To
replace them please contact the assistance service.
Electrical cable
If the power cable is damaged, it can be replaced by the
manufacturer or his technical service, to prevent any
attendant risks.
SCRAPPING
The unit is marked for conformity with European Directive
2012/19/EC, Waste Electrical and Electronic Equipment
(WEEE).Byensuringthattheunitisscrappedproperly,
the user contributes to safeguarding the environment and
public health.
The
symbol on the product or on its accompanying
documents indicates that the product may not be treated
as domestic waste but must be handed over to a sorting
centre for electrical and electronic waste. Dispose of it
inaccordancewithlocalwastedisposalregulations.For
further information on the handling, recovery and recycling
of this product, contact the local authority, domestic waste
disposal service or the reseller from whom you purchased it
Troubleshooting
If something does not work, make the following simple
checks before contacting Technical Service:
If the hood does not operate:
Check that:
• theunitispoweredup.
• aspeedhasbeenset.
If the hood is not working effectively:
Check that:
• theselectedmotor speedissufcienttohandlethe
amount of smoke and steam being produced.
• thekitchenisadequatelyventilatedfortheunittotake
air in.
• thecharcoallterisnotexhausted(lterversion).
If the hood turns off during normal operation:
Check that:
• theunitispoweredup.
• thecircuitbreakerhasnottripped.
In case of faulty operation, before contacting Technical
service,rstdisconnectthemachinefromthemainsforat
least 5 seconds by pulling its plug, then reconnect it. If the
fault persist, contact Technical Service.
* Only available in certain models