GB
11
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Grease/odour lter warnings
Thebaratthetopleftashestoindicate
thatthegreaselterissaturated.
Thebaratthetoprightashestoindicate
thattheodourlterissaturated.
Ifbothbarsareashing,thenbothlters
are saturated.
Youmustthenclean/replacethegreaselter(A) or odour
lter(B)orboth,accordingly(see“Maintenanceandcare”).
Thelatteronlyappliestothelterversion.
To reset the lter counter:
Hold down T4 for three seconds while the hood is on.
Ifbothlterwarningsareactiveatthesametime,youmust
reset each separately.
Therstsequenceresetsthegreaselter,whilethesecond
sequenceresetstheodourlter.
Conguring the hood
To set the operating mode of the hood, hold down T4 for 6
seconds. After a long beep, the type of installation displays:
Ducted
(squareatbottomleftashing).
Filter
(squareatbottomrightashing).
You can change the type of installation by pressing T4. To
quitcongurationmode,pressT1 once; this switches the
unit off and saves the last displayed setting.
Maintenance and care
Caution! Before cleaning or servicing the unit,
disconnect it from the mains by pulling the power plug
or disconnecting the main circuit breaker.
First cleaning
• Removetheprotectivelm
• Cleanwithadampspongeandalittleneutralsoap
• Rinseoffwithadampcloth
• Drywithasoftcloth;ifthehoodisstainlesssteel,dry
alongthemetal'sgrain
Periodic cleaning
The hood must be cleaned frequently (at least as often as
youservicethegreaselter),insideandout.Useadamp
cloth and a neutral liquid detergent with lukewarm water.
Do not use abrasive or corrosive products.
Warning:Failuretoobservethehoodcleaningandlter
cleaning/replacementinstructionscanresultinres.Follow
the instructions carefully. The manufacturer is not liable for
anydamagetothemotororrescausedbyincorrectcare
or failure to follow the above instructions.
Servicing the grease lter (A)
A
Thegreaselterretainsthe
particles of grease produced
during cooking; it must be
cleaned at least once a month
with a non-aggressive
detergent, either by hand or
with a low temperature, short
dishwasher cycle.
Toextract thegreaselter,
pull the spring loaded handle.
Ifwashedinadishwasher,themetalltermaychange
colour, but this does not affect its performance.
Servicing the charcoal lter (B)
B
The charcoal filter retains
unpleasant cooking odours.
The filter saturates after a
variable time, depending on
the type of cooking and how
often the grease filter is
cleaned. The cartridge must
be replaced at least once
every twenty months.
ThisltercanNOTbewashed
or regenerated
Disassembly:Rotatethelter90°toremoveitfromthe
suction assembly.
Assembly:Fit theactive-carbonlter intothe suction
assembly and rotate it 90° to secure it in place.
Replacing the bulbs
Disconnect the unit from the mains and remove the grease
lter.
Caution! Make sure the bulbs are cool before touching
them.
1.Extracttheguard
by prising it out with a small
flat head screwdriver or
something similar.
2. Replace the faulty bulb.
Use only bulbs of the
same type (for details,
see the technical data in
the following manual).
3.Rettheguard(pushitin).